Release Notes

1651 | show rf optimization-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
The output of this command includes the following parameters:
Parameter Description
Station Handoff Assist If enabled, this parameter allows the controller to force a client off an AP when
the RSSI drops below a defined minimum threshold.
Detect Association
Failure
Shows if the profile enables or disables STA association failure detection.
Coverage Hole
Detection
Shows if the profile enables or disables coverage hole detection.
Hole Good RSSI
Threshold
Time, in seconds, after a coverage hole is detected until a coverage hole event
notification is generated.
This parameter requires the RF Protect license.
Hole Good Station
Ageout
Stations with signal strength above this value are considered to have good
coverage.
This parameter requires the RF Protect license.
Hole Detection Interval Time, in seconds, after which a station with good coverage is aged out.
This parameter requires the RF Protect license.
Hole Idle Station Ageout Time, in seconds, after which a station in a poor coverage area is aged out.
This parameter requires the RF Protect license.
Hole Poor RSSI
Threshold
Stations with signal strength below this value will trigger detection of a coverage
hole.
This parameter requires the RF Protect license.
Detect interference Enables or disables interference detection.
Interference Threshold Percentage increase in the frame retry rate (FRR) or frame receive error rate
(FRER) before interference monitoring begins on a given channel.
Interference Threshold
Exceed Time
Time, in seconds, the FRR or FRER exceeds the threshold before interference is
reported.
Interference Baseline
Time
Time, in seconds, the air monitor should learn the state of the link between the
AP and client to create frame retry rate (FRR) and frame receive error rate (FRER)
baselines.
RSSI Falloff Wait Time Time, in seconds, to wait with decreasing RSSI before a deauthorization message
is sent to the client. The maximum value is 8 seconds.
Low RSSI Threshold Minimum RSSI above which deauthorization messages should never be sent.
RSSI Check Frequency Interval, in seconds, to sample RSSI.
Command History
Version Modification
ArubaOS 3.0 Base operating system
ArubaOS 3.4 Output parameters displaying load balancing status were removed. You can
now view the status of the load balancing feature via the commands show rf
dot11a-radio-profile and show rf dot11g-radio-profile.