Release Notes

1861 | show wlan ht-ssid-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Supported MCS set 0-23
.
The output of this command includes the following data columns:
Parameter Description
40 MHz channel usage
Shows if the profile enables or disables the use of 40 MHz channels.
BA AMSDU Enable
Shows of the AP has enabled or disabled the ability to receive
AMSDU in BA negotiation.
Temporal Diversity Enable
Shows if temporal diversity has been enabled or disabled. When this
feature is enabled and the client is not responding to 802.11 packets,
the AP will launch two hardware retries; if the hardware retries are not
successful then it attempts software retries.
High throughput enable (SSID)
Shows if the profile enables or disables high-throughput (802.11n)
features.
Legacy stations
Allow or disallow associations from legacy (non-HT) stations. By
default, this parameter is enabled (legacy stations are allowed).
Low-density Parity Check
If enabled, the AP will advertise Low-density Parity Check (LDPC)
support. LDPC improves data transmission over radio channels with
high levels of background noise.
Maximum number of spatial streams
usable for STBC reception
Shows the maximum number of spatial streams usable for STBC
reception. 0 disables STBC reception, 1 uses STBC for MCS 0-7.
Higher MCS values are not supported. (Supported on the W-AP90
series, W-AP130 Series, W-AP68, W-AP175 and W-AP105 only. The
configured value will be adjusted based on AP capabilities.)
NOTE: If transmit beamforming is enabled, STBC will be disabled for
disabled for beamformed frames.
Maximum number of spatial streams
usable for STBC transmission
Shows the maximum number of spatial streams usable for STBC
transmission. 0 disables STBC transmission, 1 uses STBC for MCS 0-
7. Higher MCS values are not supported. (Supported on W-AP90
series, W-AP175, W-AP130 Series and W-AP105 only. The configured
value will be adjusted based on AP capabilities.)
NOTE: If transmit beamforming is enabled, STBC will be disabled for
disabled for beamformed frames.
MPDU Aggregation
Shows if the profile enables or disables MAC protocol data unit
(MPDU) aggregation.
Max received A-MPDU size
Configured maximum size of a received aggregate MPDU, in bytes.
Max transmitted A-MPDU size
Configured maximum size of a transmitted aggregate MPDU, in
bytes.
Min MPDU start spacing
Configured minimum time between the start of adjacent MPDUs
within an aggregate MPDU, in microseconds.
Supported MCS set
Displays a list of Modulation Coding Scheme (MCS) values or ranges
of values to be supported on this SSID. The MCS you choose
determines the channel width (20MHz vs. 40MHz) and the number
of spatial streams used by the mesh node.