Release Notes

Parameter Description Range Default
source
Enter the source IPv4/IPv6 Address address for sending
traps.
— —
udp-port
The port number to which notification messages are sent. — 162
user
Configures an SNMPv3 user profile for the specified
username.
— —
auth-prot
Authentication protocol for the user, either HMAC-MD5-98
Digest Authentication Protocol (MD5) or HMAC-SHA-98
Digest Authentication Protocol (SHA), and the password for
use with the designated protocol.
MD5/SHA SHA
priv-prot
Privacy protocol for the user, either Advanced Encryption
Standard (AES) or CBC-DES Symmetric Encryption Protocol
(DES), and the password for use with the designated
protocol.
AES/DES DES
Usage Guidelines
This command configures SNMP on the controller only. You configure SNMP-related information for APs in an
SNMP profile which you apply to an AP group or to a specific AP. To configure SNMP hostname, contact, and
location information for the controller, use the hostname, syscontact, and syslocation commands.
Example
The following command configures an SNMP trap receiver:
(host) (config) #snmp-server host 191.168.1.1 version 2c 12345678
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.1 The stats parameter was introduced
ArubaOS 6.4 The IPv6 Address parameter was introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide snmp-server | 1912