Release Notes

telnet
telnet {cli|soe}
Description
Enable telnet to the controller or to an AP through the controller.
Syntax
Parameter Description Default
cli
Enable telnet using the CLI. Disabled
soe
Enable telnet using Serial over Ethernet (SoE). Disabled
Usage Guidelines
Use the cli option to enable telnet to the controller.
Use the soe option to enable telnet using the SoE protocol. This allows you to remotely manage an AP directly
connected to the controller.
Example
The following example enables telnet to the controller using the CLI.
(host) (config) #telnet cli
Command History
The command was introduced in ArubaOS 1.0
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide telnet | 1930