Release Notes

the hotspot AP.
Values configured in this profile will not be sent to clients unless you:
1. Associate the ANQP IP Address Availability profile with an ANQP advertisement profile. (wlan hotspot
advertisement profile <profile-name> anqp-ip-addr-avail-profile <profile-name> )
2. Associate the ANQP advertisement profile with a Hotspot profile. (wlan hotspot h2-profile
advertisement-profile <profile-name>)
3. Enable the hotspot feature within that Hotspot profile. (wlan hotspot h2-profile <profile-name>
hotspot-enable )
Example
The following command configures an AP using this profile to advertise a public IPv4 network.
wlan hotspot anqp-ip-addr-avail-profile default
ipv4-addr-avail public
ipv6-addr-avail not-available
Command History
This command was introduced in ArubaOS 6.4
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide wlan hotspot anqp-ip-addr-avail-profile | 2034