Release Notes

apboot
apboot {all [global|local]|ap-group <group> [global|local]|ap-name <name>|ip-addr
<ipaddr>|wired-mac <macaddr>}
Description
This command reboots the specified APs.
Syntax
Parameter Description Default
all
Reboot all APs. all
global
Reboot APs on all controllers. global
local
Reboot only APs registered on this controller. This
is the default.
local
ap-group
Reboot APs in a specified group. ap-group
global
Reboot APs on all controllers. global
local
Reboot only APs registered on this controller. This
is the default.
local
ap-name
Reboot the AP with the specified name. ap-name
ip-addr
Reboot the AP at the specified IP address. ip-addr
wired-mac
Reboot the AP at the specified MAC address. wired-mac
Usage Guidelines
You should not normally need to use this command as APs automatically reboot when you reprovision them.
Use this command only when directed to do so by your Dell representative.
Example
The following command reboots a specific AP:
(host)(config)# apboot ap-name Building3-Lobby
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide apboot | 206