Release Notes

215 | ap-leds Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
ap-leds
ap-leds
{all | ap-group <ap-group> | ap-name <ap-name> | ip-addr <ip address> | wired-mac <mac
address>} {global blink|normal}|{local blink|normal}
Description
This command allows you to set the behavior of an AP’s LEDs.
Syntax
Parameter Description
all
Controls the LED behavior for all APs
ap-group <ap-group>
Controls the LED behavior for APs in the specified group
ap-name <ap-name>
Controls the LED behavior for the AP with the specified name
ip-addr <ip-addr>
Controls the LED behavior for the AP with the specified IP address
wired-mac <mac-addr>
Controls the LED behavior for the AP with the specified MAC address
global
Selects all APs on all controllers
local
Selects all APs registered on this controller
blink
Causes the LEDs to blink for identification
normal
Restores the LEDs to their normal behavior
Usage Guidelines
Use the ap-leds command to make the LEDs on a defined set of APs either blink or display in the currently
configured LED operating mode. Note that if the LED operating mode defined in the AP’s system profile is set
to “off”, then the normal parameter in the ap-leds command will disable the LEDs. If the LED operating mode
in the AP system profile is set to “normal” then the normal parameter in this command will allow the LEDs light
as usual.
Example
The following command causes all local APs to blink their LEDs for identification purposes:
ap-leds all local blink
Command History
Release Modification
ArubaOS 3.0 Command introduced