Release Notes

339 | firewall Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
deny-inter-user-bridging
Prevents the forwarding of
Layer2 traffic between wired or
wireless users. You can
configure user role policies that
prevent Layer3 traffic between
users or networks but this does
not block Layer2 traffic. This
option can be used to prevent
traffic, such as Appletalk or IPX
from being forwarded. If
enabled, traffic (all non-IP traffic)
to untrusted port or tunnel is
also blocked.
— disabled
deny-inter-user-traffic
Denies downstream traffic
between users in a wireless
network (untrusted users) by
disallowing layer2 and layer3
traffic. This parameter does not
depend on the deny-inter-
user-bridging parameter
being enabled or disabled.
— disabled
deny-source-routing
Disallows forwarding of IP frames
with source routing with the
source routing options set.
— disabled
disable-ftp-server
Disables the FTP server on the
controller. Enabling this option
prevents FTP transfers.
Enabling this option could cause
APs to not boot up. You should
not enable this option unless
instructed to do so by a Dell
representative.
— disabled
disable-stateful-h323-
processing
Disables stateful H.323
processing.
— disabled
disable-stateful-sccp-processing
Disables SCCP processing. — disabled
disable-stateful-sip-processing
Disables monitoring of
exchanges between a voice over
IP or voice over WLAN device
and a SIP server. This option
should be enabled only when
there is no VoIP or VoWLAN
traffic on the network.
— disabled
disable-stateful-sips-processing
Configure the controller to read
SIP signaling messages sent by
Lync clients on port 5061.
— enabled
disable-stateful-ua-processing
Disables stateful UA processing. — disabled
disable-stateful-vocera-processing
Disables stateful VOCERA
processing.
— disabled