Release Notes

Parameter Description Range Default
dpi
Enables Deep-Packet Inspection
(DPI)
— disabled
drop-ip-fragments
When enabled, all IP fragments
are dropped. You should not
enable this option unless
instructed to do so by a Dell
representative.
— disabled
enable-bridging
Enables bridging when the con-
troller is in factory default.
— disabled
enable-per-packet-logging
Enables logging of every packet
if logging is enabled for the
corresponding session rule.
Normally, one event is logged
per session. If you enable this
option, each packet in the
session is logged. You should
not enable this option unless
instructed to do so by a Dell
representative, as doing so may
create unnecessary overhead
on the controller.
— disabled
enforce-tcp-handshake
Prevents data from passing
between two clients until the
three-way TCP handshake has
been performed. This option
should be disabled when you
have mobile clients on the
network as enabling this option
will cause mobility to fail. You
can enable this option if there
are no mobile clients on the
network.
— disabled
enforce-tcp-sequence
Enforces the TCP sequence
numbers for all packets.
— disabled
gre-call-id-processing
Creates a unique state for each
PPTP tunnel. Do not enable this
option unless instructed to do so
by a technical support
representative.
— disabled
imm-fb
Immediately free buffers on W-
7200 controllers. Do not enable
this option unless instructed to do
so by a technical support rep-
resentative.
— —
jumbo
Enables jumbo frames pro-
cessing.
— disabled
local-valid-users
Adds only IP addresses, which
belong to a local subnet, to the
user-table.
— disabled
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide firewall | 340