Release Notes

405 | interface fastethernet | gig-
abitethernet
Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
interface fastethernet | gigabitethernet
interface
interface {fastethernet|gigabitethernet} <slot>/<port>
description <string>
duplex {auto|full|half}
ip access-group <acl> {in|out|session {vlan <vlanId>}}
tunneled-node-port
no ...
poe [cisco]
jumbo
lldp {fast-transmit-counter <1-8>|fast-transmit-interval <1-
3600>|med|receive|transmit|transmit-hold <1-100>|transmit-interval <1-3600> }600>
port monitor {fastethernet|gigabitethernet} <slot>/<port>
priority-map <name>
shutdown
spanning-tree [cost <value>] [port-priority <value>] [portfast]
speed {10|100|auto}
switchport {access vlan <vlan>|mode {access|trunk}|
trunk {allowed vlan {<vlans>|add <vlans>|all|except <vlans>|remove <vlans>}|
native vlan <vlan>}}
trusted {vlan <word>}
xsec {point-to-point <macaddr> <key> allowed vlan <vlans> [<mtu>]|vlan <vlan>}
Description
This command configures a FastEthernet or GigabitEthernet interface on the controller.
Syntax
Parameter
Description Range Default
<slot>
<slot> is always 1. — —
<port>
Number assigned to the network
interface embedded in the
controller.Port numbers start at 0
from the left-most position.
— —
description
String that describes this interface. — —
duplex
Transmission mode on the
interface: full or half-duplex or
auto to automatically adjust
transmission.
auto/full/half auto
ip access-group
Applies the specified access
control list (ACL) to the interface.
Use the ip access-list command
to configure an ACL.
NOTE: This parameter requires
the PEFNG license.
— —
in
Applies ACL to interface’s inbound
traffic.
— —
out
Applies ACL to interface’s
outbound traffic.
— —