Release Notes

Parameter
Description Range Default
session
Applies session ACL to interface
and optionally to a selected VLAN
associated with this port.
— —
tunneled-node-port
Enable tunneled node capability on
the interface.
— disabled
no
Negates any configured
parameter.
— —
poe
Enables Power-over-Ethernet
(PoE) on the interface.
— enabled
cisco
Enables Cisco-style PoE on the
interface.
— disabled
jumbo
Enables or disables jumbo frame
MTU configured via firewall on a
port.
— disabled
lldp
Configures an LLDP functionality
on an interface.
— —
fast-transmit-counter <1-8>
Set the number of the LLDP data
units sent each time fast LLDP
data unit transmission is triggered
1-8 4
fast-transmit-interval <1-3600>
Set the LLDP fast transmission inter-
val in seconds.
1-3600 1
med
Enables the LLDP MED protocol. — disabled
receive
Enables processing of LLDP PDU
received.
— disabled
transmit
Enables LLDP PDU transmit. — disabled
transmit-hold <1-100>
Set the transmit hold multiplier. 1-100 4
transmit-interval <1-3600>
Sets the transmit interval in
seconds.
1-3600 30
port monitor
Monitors another interface on the
controller.
— —
priority-map
Applies a priority map to the
interface. Use the priority-map
command to configure a priority
map which allows you to map ToS
and CoS values into high priority
traffic queues.
— —
shutdown
Causes a hard shutdown of the
interface.
— —
spanning-tree
Enables Rapid spanning tree or
Per-VLAN spanning tree
— enabled
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide interface fastethernet | gigabitethernet | 406