Release Notes

467 | ip nat Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
ip nat
ip nat pool <name> <start-ipaddr> <end-ipaddr> [<dest-ipaddr>]
Description
This command configures a pool of IP addresses for network address translation (NAT).
Syntax
Parameter Description
pool
Name of the NAT pool.
<start-ipaddr>
IP address that defines the beginning of the range of source NAT addresses in the
pool.
<end-ipaddr>
IP address that defines the end of the range of source NAT addresses in the pool.
<dest-ipaddr>
Destination NAT IP address.
Usage Guidelines
This command configures a NAT pool which you can reference in a session ACL rule (see ip access-list session on
page 440).
Example
The following command configures a NAT pool:
(host) (config) #ip nat pool 2net 2.1.1.1 2.1.1.125
Command History
This command was available in ArubaOS 3.0.
Command Information
Platform License Command Mode
Available on all platforms This command requires the PEFNG
license.
Config mode on master and local
controllers