Release Notes
587 | paging Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
paging
paging
Description
This command stops the command output from printing continuously to the terminal.
Syntax
No parameters
Usage Guidelines
By default, paging is enabled.
With paging enabled, there is a pause mechanism that stops the command output from printing continuously
to the terminal. If paging is disabled, the output prints continuously to the terminal. To disable paging, use the
nopaging command. You must be in enable mode to disable paging.
The paging setting is active on a per-user session. For example, if you disable paging from the CLI, it only affects
that session. For new or existing sessions, paging is enabled by default.
You can also configure the number of lines of text displayed when paging is enabled. For more information,
refer to the command page on page 586.
If you need to adjust the screen size, use your terminal application to do so.
Example
The following command enables paging:
(host) (config) #paging
Command History
This command was introduced in ArubaOS 1.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config and Enable mode on master
controllers