Release Notes

599 | pkt-trace Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
pkt-trace
pkt-trace acl <acl-name> {enable|disable} [trace {cptrace|pktrace} [trace-mask <tmask>]]]
Description
Enable packet tracing in the datapath. Use this feature only under the supervision of Dell technical support.
Syntax
Parameter Description
<acl-name>
Enable packet tracing for the specified access-control list.
enable
Enable packet tracing for the ACL.
disable
Disable packet tracing for the ACL.
cptrace
Send packet trace data into the Control Processor.
pktrace
Write packet trace data in the packet.
tracemask <tmask>
Specify the trace mask. This value will be provided by Dell technical support.
Example
The following example enables packet tracing for the traffic matching the acl stateful-dot1x.
(host) #pkt-trace acl stateful-dot1x enable trace cptrace trace-mask <val>
Command History
This command was introduced in ArubaOS 3.4.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable mode on master controllers