Release Notes

P-
a-
r-
a-
m-
e-
t-
e-
r
Description
R-
a-
n-
g-
e
re
a
d-
b
o
ot
in
fo
Retrieves current provisioning parameters of the specified AP.
NOTE: This parameter can only be used on the master controller.
—
re
pr
o
vi
si
o
n
Provisions one or more APs with the values in the provisioning-params workspace. To use reprovision, you
must use read-bootinfo to retrieve the current values of the APs into the provisioning-ap-list.
NOTE: This parameter can only be used on the master controller.
—
re
s
e
t-
b
o
ot
in
fo
Restores factory default provisioning parameters to the specified AP.
NOTE: This parameter can only be used on the master controller.
—
sc
h-
m
o
d
e-
ra
di
o-
0
If you are provisioning an 802.11n-capable AP, you can issue the sch-mode-radio-0
command to enable single-chain mode for the selected radio. AP radios in single-chain
mode will transmit and receive data using only legacy rates and single-stream HT
rates up to MCS 7. This setting is disabled by default.
sc
h-
m
o
d
e-
ra
di
o-
1
If you are provisioning an 802.11n-capable AP, you can issue the sch-mode-radio-1 command to enable
single-chain mode for the selected radio. AP radios in single-chain mode will transmit and receive data
using only legacy rates and single-stream HT rates up to MCS 7. This setting is disabled by default.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide provision-ap | 622