Release Notes

629 | provision-ap Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
The following are useful commands when provisioning one or more APs:
l show|clear provisioning-ap-list displays or clears the APs that will be provisioned.
l show|clear provisioning-params displays or resets values in the provisioning-params workspace.
l show ap provisioning shows the provisioning parameters an AP is currently using.
Example
The following commands change the IP address of the master controller on the AP:
(host) (config) #provision-ap
read-bootinfo ap-name lab103
show provisioning-ap-list
copy-provisioning-params ap-name lab103
master 10.100.102.210
reprovision ap-name lab103
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for the mesh parameters, additional antenna
parameters, and AP location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l installation
l mesh-sae
l set-ikepsk-by-addr
l usb-dev
l usb-dial
l usb-init
l usb-passwd
l usb-tty
l usb-type
l usb-user
l link-priority-cellular
l link-priority-ethernet
ArubaOS 5.0 The mesh-sae parameter no longer has the sae-default option. Use the
sae-disable option to return this parameter to its default disabled setting.
ArubaOS 6.0 The uplink-vlan parameter was introduced.
ArubaOS 6.1 The following new parameters were introduced for provisioning IPv6 APs:
l dns-server-ip6
l ip6addr
l ip6prefix
l gateway6
ArubaOS 6.2 The following new parameters provision APs in single-chain mode:
l sch-mode-radio-0
l sch-mode-radio-1
The following new parameters provision APs for 802.1X authentication:
l apdot1x-passwd
l apdot1x-username
The following new parameters provision Remote APs using USB modems: