Release Notes

643 | remote-node-profile (deprecated) Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
priority-map <name>
Priority Map specification, used to prioritize the incoming
packets on an interface. For details on using this command,
see priority-map on page 603.
remote-node-dhcp-pool <pool_name>
Name of the DHCP pool.
pool-type {vlan <id>}|tunnel
Specify whether you are creating a pool of IP addresses for
RN VLANs or RN tunnels.
<id>
The ID number of the VLAN associated with the RN.
<start-ip>
IP addresses at the start and end of the RN’s address range,
in dotted-decimal format.
<end-ip>
IP address at the end of the RN’s address range, in dotted-
decimal format.
num_hosts
Maximum number of hosts supported by an RN using this
pool.
router ospf <area-id>
Enables and configures OSPF. Configure an OSP area, control
distribution of default information, redistribute the route,
configure the Router ID and specific the subnet.
snmp-server
Enables SNMP and modifies SNMP parameters. For details
on using this command, see snmp-server on page 1911.
spanning-tree
Create a Spanning Tree Subsystem. For details on using this
command, see spanning-tree (Global Configuration) on page
1913.
syscontact <syscontact>
Configures the name of the system contact for the controller.
Enter an alphanumeric string that specifies the name of the
system contact.
syslocation <syslocation>
Configures the name of the system location for the
controller. Enter an alphanumeric string that specifies the
name of the system location.
uplink
Define an uplink manager configuration. For details on using
this command, see uplink on page 1945.
validate
After you have defined configuration settings for a Remote
Node profile, you must activate that profile by issuing the
command remote-node-profile <profile-name> validate
to validate that the configuration has a correctly defined
uplink, model type, and an interface type supported by the
Remote Node model.
You cannot assign a Remote Node configuration profile to a
Remote Node until that profile has been activated.
vlan
Create a Remote Node VLAN Virtual Interface vlan. For
details on using this command, see vlan on page 1958.
vrrp
Define a Virtual Router Redundancy Protocol (VRRP)
configuration. For details on using this command, see vrrp on
page 1978.