Release Notes

The following command configures APs to operate in high-throughput (802.11n) mode on the
5 Ghz frequency band for the selected dot11a-radio profile named “samplea” and assigns a high-throughout
radio profile named “default-a:”
(host) (config) #rf dot11a-radio-profile samplea
high-throughput-enable
ht-radio-profile default-a
The following command configures a primary channel number of 157 and a secondary channel number of 161
for 40 MHz mode of operation for the selected dot11a-radio profile named “samplea:”
(host) (config) #rf dot11a-radio-profile samplea
channel <157+>
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.2 Introduced support for the high-throughput IEEE 802.11n standard.
ArubaOS 3.4 Support for the following parameters:
l Spectrum load balancing
l Spectrum load balancing domain
l RX Sensitivity Tuning Based Channel Reuse
l RX Sensitivity Threshold
l ARM/WIDS Override
ArubaOS 3.4.1 The maximum-distance parameter was introduced.
ArubaOS 3.4.2 The beacon-regulate parameter was introduced.
ArubaOS 6.0 Support for the following parameters:
l am-scan-profile
l cap-reg-eirp
l slb-mode
l slb-update-interval
ArubaOS 6.1 The spectrum-monitoring and slb-threshold parameters were introduced.
ArubaOS 6.1.3.2 The cell-size-reduction parameter was introduced.
ArubaOS 6.3 The very-high-throughput-enable parameter was introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide rf dot11a-radio-profile | 672