Release Notes

show ap database
show ap database {flags|group<group>|inactive|indoor|local|long|outdoor|{page<page>}|
sensors [disconnected]|sort-by [ap-flags|ap-group|ap-ip|
ap-mac|ap-name|ap-serial|ap-type|fqln|provisioned|status {up|down}|switch-ip]|sort-direction
[ascending|descending]|start <start> |status {up|down]|switch <switch-ip-
addr>|unprovisioned|usb}
Description
Show the list of access points in the controller’s database.
Syntax
Parameter Description
flags
Show only APs with flags set [LUDINRCc12ME] .
group <group>
Show data for a specified AP group.
inactive
Show only local APs with no active BSSIDs or wired
AP interfaces.
indoor
Show only APs that have an installation mode set to “indoor.”
local
Show only APs connected to this controller.
long
Display the following additional data columns:
l Wired MAC Address,
l Serial #
l Slot/Port
l FQLN
l Service Tag
outdoor
Show only APs that have an installation mode set to “outdoor.”
page <page>
Display a limited number of APs by entering the number of APs to be
displayed in the output of this command.
disconnected
Show only disconnected RFprotect sensors.
sort-by
Sort the output of this command by a specific data column.
ap-flags
Sort by AP flags.
ap-group
Sort by AP group name.
ap-ip
Sort by AP group name.
ap-mac
Sort by AP wired MAC address .
ap-name
Sort by AP name .
ap-serial
Sort by AP serial number.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap database | 940