Users Guide

1101 | External Services Interface Dell Networking W-Series ArubaOS 6.4.x| User Guide
Choose from existing configured policies, create a new policy based on existing policies, or create a new
policy.
a. If you elect to create a new policy, click on the radio button for Create New Policy and then click
Create. The WebUI displays the Policies tab.
b. In the Policies tab:
Policy Name. Enter the policy name fortinet and the IPv4 Session policy type.) Click Add to proceed.
The WebUI expands the Policies tab.
In the drop-down lists, choose parameters such as source, destination, service in the same way as other
firewall policy rules. This example uses any source, any destination, service type svc-http (tcp 80). For
certain choices, the WebUI expands and adds drop-down lists.
c. In the Action drop-down menu, select the redirect to ESI group option.
Select fortinet as the appropriate ESI group.
The three steps above translate to “for any incoming HTTP traffic, going to any destination, redirect the
traffic to servers in the ESI group named fortinet.”)
Select both as the traffic direction. Forward refers to the direction of traffic from the untrusted client or
user to the trusted server, such as the HTTP server or email server.
To add this rule to the policy, click Add.
d. Repeat the steps to configure additional rules. This example adds a rule that specifies
any,any,any,permit.
e. Click Done to return to the User Roles tab.
4. Click Apply to apply the configuration changes.
5. Refer to
Roles and Policies on page 438, for directions on how to apply a policy to a user role.
In the CLI
Use these commands to define the redirection filter for sending traffic to the ESI server and apply the firewall
policy to a user role in the route-mode ESI topology example.
ip access-listsessionpolicy
anyanyanyredirectesi-groupgroupdirectionbothblacklist
//For any incoming traffic, going to any destination,
//redirect the traffic to servers in the specified ESI group.
anyanyanypermit
//For everything else, allow the traffic to flow normally.
user-rolerole
access-list{eth|mac|session}
bandwidth-contractname
captive-portalname
dialername
pool {l2tp|pptp}
reauthentication-intervalminutes
session-aclname
vlanvlan_id
Syslog Parser Domain and Rules
The following sections describe how to configure the syslog parser domain and rules for the route-mode
example using the WebUI and CLI.
In the WebUI
Adding a New Syslog Parser Domain
To add a new syslog parser domain for the routed example: