Users Guide

temporal-diversity
You can also create a new mesh high-throughput SSID profile by copying the settings of an existing profile
using the clone parameter. Using the clone command to create a new profile makes it easier to keep constant
attributes in common within multiple profiles.
ap mesh-ht-ssid-profile <profile-name> clone <source-profile-name>
Assigning a Profile to an AP Group
To associate a mesh high-throughput SSID profile with an AP group:
(host)(config) #ap-group <group> mesh-ht-ssid-profile <profile-name>
To associate a mesh radio profile with an individual AP:
(host)(config) #ap-name <name> mesh-ht-ssid-profile <profile-name>
Viewing High-throughput SSID Settings
To view a complete list of high-throughput profiles and their status:
(host)(config) #show ap mesh-ht-ssid-profile
To view the settings of a specific high-throughput profile:
(host)(config) #show ap mesh-ht-ssid-profile <profile-name>
Deleting a Profile
If no AP or AP group is using a mesh high-throughput SSID profile, you can delete that profile using the no
parameter:
(host)(config) no ap mesh-ht-ssid-profile <profile-name>
Configuring Ethernet Ports for Mesh
If you use mesh to join multiple Ethernet LANs, configure and enable bridging on the mesh point Ethernet port
This section describes how to configure Ethernet ports for bridging or secure jack operation using the wired AP
profile. The wired AP profile controls the configuration of the Ethernet port(s) on your AP.
Mesh nodes only support bridge mode and tunnel mode on their wired ports (enet0 or enet1). Split tunnel mode is
not supported. Use bridge mode to configure bridging on the mesh point Ethernet port. Use tunnel mode to configure
secure jack operation on the mesh node Ethernet port.
When configuring the Ethernet ports on dual-port APs, note the following requirements for the AP configures
as a mesh portal:
l Connect enet0 to the controller to obtain an IP address. The wired AP profile controls enet1.
l Only enet1 supports secure jack operation.
Configuring Bridging on the Ethernet Port
Use the following procedure to configure bridging on the Ethernet port via the WebUI.
1. Navigate to the Configuration > Wireless > AP Configuration > AP Group window.
2. Click the AP group name with the wired ap profile you want to edit.
3. Under the Profiles list, expand the AP menu, then select Wired AP profile. The settings for the currently
selected wired AP profile appear.
You can use a different wired AP profile by selecting a profile from the Wired AP profile drop-down list.
4. Under Profile Details, do the following:
a. Select the Wired AP enable check box. This option is not selected by default.
Dell Networking W-Series ArubaOS 6.4.x | User Guide Secure Enterprise Mesh |
652