Administrator Guide

1058 | AirGroup Dell Networking W-Series ArubaOS 6.4.x| User Guide
Column Description
Timer Value
Displays the number of hours.
Unit
Displays the unit in hours.
Table 235: show airgroup cppm-server query-interval
Defining a CPPM and RFC3576 Server
You must define one or more CPPM servers to be used by the AirGroup RADIUS client, and an RFC 3576
(dynamic authorization) server. If multiple CPPM servers are defined, the servers are listed in a sequential
order. The AirGroup RADIUS client will use the first available server on this list.
Table 236 describes the configuration parameters for a CPPM server.
Parameter Description
Host IP address or fully qualified domain name (FQDN) of the authentication
server. The maximum supported FQDN length is 63 characters.
Key Shared secret between the controller and the authentication server. The
maximum length is 128 characters.
Authentication Ports
Authentication port on the server.
Default: 1812
Accounting Ports
Accounting port on the server.
Default: 1813
Retransmits
Maximum number of retries sent to the server by the controller before
the server is marked as down.
Default: 3
Timeout
Maximum time, in seconds, that the controller waits before timing out the
request and resending it.
Default: 5 seconds
NAS ID
Network Access Server (NAS) identifier to use in RADIUS packets.
NAS IP
NAS IP address to send in RADIUS packets.
You can configure a “global” NAS IP address that the controller can use
for communications with all CPPM servers. However, that the controller
will only use this global NAS IP if you do not configure a server-specific
NAS IP. To set the global NAS IP in the WebUI, navigate to the
Configuration > Security > Authentication > Advanced page.
Table 236: CPPM Server Configuration Parameters