Deployment Guide

10 | W-7010 Controller Dell Networking W-7010 Controller | Installation Guide
Uplink Ports
The W-7010 controller includes two 1000BASE-X uplink ports (16 and 17). See Figure 4. It is recommended to
use Dell supported SFP transceivers in these ports.
Figure 4 Ports, LEDs, and LCD Panel
STATUS Port status Administrative Green (Solid) Port enabled
Off Port Administratively disabled
Duplex Green (Solid) Full-duplex
Off Half-duplex
PoE Green (Solid) PoE enabled
Green (Blinking) Power enabled, but power denied due to unavailability
Off PoE not enabled
Speed Green (Solid) 1000 Mbps
Off 10/100 Mbps
Table 6 10/100/1000BASE-T Ethernet Port LEDs (Continued)
LED Function LCD Mode Indicator Status
NOTE: Dell tests and supports Dell optics within Dell controller systems. Third party optics are not tested or supported; therefore,
Dell does not guarantee proper functionality of third party optics when used in a Dell system.