Deployment Guide

Dell Networking W-7010 Controller | Installation Guide W-7010 Controller | 11
Each uplink port has two LEDs that allow basic monitoring of link/port status and activity.
Power, Status, and Peered LEDs
The front panel also includes Power, Status, and Peered LEDs that provide basic monitoring of the overall status
of the W-7010 controller. See Figure 4 on page 10.
LCD Panel
The W-7010 controller is equipped with an LCD panel (see Figure 4 on page 10.) that displays information about
the controller’s status, and provides a menu that allows basic operations, such as initial setup and reboot. The
LCD panel displays two lines of text with a maximum of 16 characters per line. When using the LCD panel, the
active line is indicated by an arrow next to the first letter.
The LCD panel is operated using the two navigation buttons to the right of the screen.
 Menu: Allows navigation through the menus of the LCD panel.
 Enter: Confirms and executes the action currently displayed on the LCD panel.
Table 7 Uplink Port LEDs
Label Function LCD Mode Indicator Status
LINK/ACT Link status NA Green (solid) Link has been established
Green (blinking) Port is transmitting or receiving data
Off No link on port
STATUS Port status Administrative Green (solid) Port enabled
Off Port disabled
Duplex Green (solid) Full-duplex
Off N/A
PoE Off N/A
Speed Green (solid) 1 Gbps
Off N/A
Table 8 Power, Status, and Peered LEDs
LED Function Indicator Status
Power System Power Green (Solid) Power On
Off Power Off
Status System Status Green (Solid) Operational
Green (Blinking) Device is loading software
Amber (Blinking) Major alarm
Amber (Solid) Critical alarm
Off No power
Peered Reserved for future use N/A N/A