Deployment Guide
Dell Networking W-7010 Controller | Installation Guide W-7010 Controller | 13
To disable only the Maintenance menu or one of its sub-menus, enter the Enable mode and use the following
CLI commands:
(host) #configure terminal
(host) (config) #lcd
(host) (lcd-menu) #disable menu maintenance ?
factory-default
halt-system
media-eject
reload-system
upgrade-image
upload-config
(host) (lcd-menu) #disable menu maintenance upgrade-image ?
partition0
partition1
USB Interface
The W-7010 controller is equipped with a USB 2.0 interface. See Figure 4 on page 10. A USB storage device can
be used to save and upload configurations to the controller. USB functions are controlled through the LCD panel
on the front of the controller. For more information on the LCD panel and its functions, see “LCD Panel” on
page11.
Management Port
The W-7010 controller is equipped with a 10/100/1000BASE-T Gigabit Management (RJ-45) port. See Figure 4
on page 10.
The management port provides 10/100/1000 Mbps Ethernet access to the W-7010 controller CLI, SNMP, and
Web interface for complete system management and troubleshooting. It can also be used to connect to a separate
management network.
The management port has a LINK/ACT LED on its left side and SPEED LED on its right side. During operation,
these LEDs provide status information as shown in the following table:
Mini-USB Console Connector
The W-7010 controller is equipped with one Mini-USB (type B) connector that provides console access for direct
local access. See Figure 4 on page 10. If both Mini-USB and RJ-45 Console ports are connected, the Mini-USB
connection takes precedence over the RJ-45 Console connection.
Mini-USB Driver
To use the Mini-USB console port, install the Dell Mini-USB driver on the computer that will manage the
controller. The driver is available on download.dell-pcw.com under Tools & Resources.
Table 10 10/100/1000BASE-T (RJ-45) Management Port
LED Function Indicator Status
LINK/ACT Link Status Information Green (Solid) Link has been established
Green (Blinking) Link activity
Off No link on port
SPEED Interface Speed Green (Solid) 1000Mbps
Off 10/100Mbps