Deployment Guide

14 | W-7010 Controller Dell Networking W-7010 Controller | Installation Guide
Console Port
Use the serial Console port to allow direct local management. See Figure 4 on page 10. This port is an RJ-45
female connector that accepts an RS-232 serial cable with a male connector.
Figure 5 Serial Console Port Pin-Out
The communication settings for the Console port is shown in the following table:
Serial Console Port Adaptor
A modular adaptor can be used to convert the female RJ-45 connector to a male DB9 connector. See Figure 6 for
complete details.
Figure 6 RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion
Power Supply
The W-7010 controller is equipped with an integrated AC power supply of 225W. The integrated power supply
supports 75W of system power and 150W of PoE power.
PoE
The W-7010 controller supports PoE (802.3af) and PoE+ (802.3at) to provide power to connected devices. PoE/
PoE+ is enabled by default to provide plug and play capability for PoE capable devices. The W-7010 controller
supports PoE management in Dynamic mode.
Table 11 Console Terminal Settings
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None
Serial
Console Port
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
Direction
Input
Output
GND
CAUTION: The Console port is compatible only with RS-232 devices. Non-RS-232 devices, such as APs, are not supported.
CAUTION: Do not connect the Console port to an Ethernet switch or a PoE power source. This may damage the controller.
3
4
5
2
5
63
RJ-45 DB-9
Internal
Connections
TxD
GND
RxD
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
DB-9 Male
Pin-Out
TxD
RxD
Ground
5
4
3
2
1
9
8
7
6