Deployment Guide

Dell Networking W-7010 Controller | Installation Guide Installation | 19
Installation Steps
To install a W-7010 controller in a two-post 19-inch Telco rack:
1. Place the mounting brackets over the mounting holes on the controller (see Figure 7).
2. Secure the brackets to the controller using the eight screws for the mounting bracket (four per bracket) and a
suitable screwdriver.
Figure 7 Attaching the Mounting Brackets for Rack Mounting
3. In the desired rack system, if the rack requires cage nut or clip nut, insert it on the front rails (two per rail,
aligned horizontally).
4. Mount the controller in the desired rack system using the four screws for system rack mount (two per bracket)
and a suitable screwdriver (see Figure 8).
Figure 8 Rack Mounting
NOTE: Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and
ventilation. Leave additional space in the front and the back of the controller to access network cables, LED status indicators,
and power cord.