Deployment Guide

22 |Installation Dell Networking W-7010 Controller | Installation Guide
Connecting and Disconnecting the AC Power Cord
Once the controller is installed, it is ready to be powered on. The W-7010 controller is not equipped with an On/
Off switch. The device will power on when the AC power cord is connected to the power supply and an AC power
outlet.
Connecting the AC Power Cord
To connect the AC power cord to the W-7010 controller:
1. Lift the power cord retaining clip so that it is not blocking the AC power connector.
2. Insert the coupler end of the AC power cord into the AC power connector on the power supply module.
3. Lower the power cord retaining clip over the AC power cord.
The W-7010 controller should now be receiving power.
Disconnecting the AC Power Cord
To disconnect the AC power cord from the W-7010 controller:
1. Lift the power cord retaining clip off the AC power cord.
2. Pull the AC power cord from the power supply module.
3. The W-7010 controller is now turned Off.
Installing an SFP
To install an SFP module into the W-7010 controller:
1. Slide the SFP module, top side facing upward, into a 1000Base-X port until a connection is made and an
audible click is heard (see Figure 12).
Figure 12 Installing an SFP
NOTE: Use standard ESD precautions when installing or removing an SFP.