Installation manual

Dell PowerConnect W-7200 Series Controller | Installation Guide Installation | 25
2. Align the new fan tray module with opening in the controller, as shown in Figure 12.
3. Pull down the hinged captive screws on the new fan tray module and align its tabs with the slots on either side
of the opening.
4. Slide the fan tray module into the controller.
5. Lift both the hinged captive screws into the lock position then secure the fan tray module by tightening the
captive screws.
Figure 12 Installing a Fan Tray
CAUTION: Ensure that fan tray module is correctly aligned with the opening on the W-7200. Failure to do so can result in damage
to the fan tray module.