Users Guide

Dell PowerConnect W-AirWave |User Guide Using VisualRF | 261
Starting VisualRF
In order to launch VisualRF, it must be enabled within AMP Setup to display the VisualRF tab, and the VisualRF
engine must be switched on in VisualRF > Setup. Both of these pages are visible to logged-in administrators
only. By default, VisualRF is disabled in new AMP installations.
To enable VisualRF, follow these instructions while logged in as an administrator:
1. Go to AMP Setup > General.
2. Scroll down to the AMP Features section as shown in Figure 194. In the field Display VisualRF, select Yes.
Then select Save.
Figure 194 AMP Setup > General > AMP Features Page Illustration
3. After the VisualRF tab is visible, navigate to VisualRF > Setup.
4. In the Server Settings section, select Yes in the Enable VisualRF Engine field. Then select Save.
Figure 195 VisualRF > Setup > Server Settings Section
Basic QuickView Navigation
The top-level menus of VisualRF are split into two major categories: Network and Mesh, as shown in Figure 196
and Figure 197. Selecting these menus will cause relevant submenus and sections to display below:
Figure 196 Default VisualRF Top Level Menu - Network View
Figure 197 Default VisualRF Top Level Menu - Mesh View
Table 143 describes the top level icons and their functions on VisualRF.
Table 143 Top Level Icons and Descriptions
Operation Icon Description
Refresh Refresh the floor plan to see changes.
Open Site Tree Display the Network Tree View Window on top of the floor plan.
Preferences Configure personal viewing preferences. The Preferences menu allows you
to configure user preferences (overlay types, grid lines, alerts, icon sizes).
See “Configuring QuickView Personal Preferences” on page268 for more
details.