Users Guide
62 | Configuring AMP Dell PowerConnect W-AirWave |Version 7.3
2. After you have completed all fields, select Save. AMP is now configured to gather rogue information from
WLSE rogue scans. As a result of this configuration, any rogues found by WLSE appear on the RAPIDS >
List page.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.
Complete the required configurations in this chapter before proceeding.
Configuring ACS Servers
This is an optional configuration. The AMP Setup > ACS page allows AMP to poll one or more Cisco ACS
servers for wireless username information. When you specify an ACS server, AMP gathers information about your
wireless users. Refer to “Configuring ACS for WDS Authentication” on page61 if you want to use your ACS
server to manage your AMP users.
Perform these steps to configure ACS servers:
1. Go to the AMP Setup > ACS page. This page displays current ACS setup, as illustrated in Figure 32.
Figure 32 AMP Setup > ACS Page Illustration
Port 1741 Defines the port AMP uses to communicate with the WLSE server.
Username None Defines the username AMP uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server
and on AMP.
The user needs permission to display faults to discover rogues and inventory
API (XML API) to discover manageable APs. As derived from a Cisco limitation,
only credentials with alphanumeric characters (that have only letters and
numbers, not other symbols) allow AMP to pull the necessary XML APIs.
Password None Defines the password AMP uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server
and on AMP.
As derived from a Cisco limitation, only credentials with alphanumeric
characters (that have only letters and numbers, not other symbols) allow AMP
to pull the necessary XML APIs.
Poll for AP Discovery; Poll for
Rogue Discovery
Yes Sets the method by which AMP uses WLSE to poll for discovery of new APs
and/or new rogue devices on the network.
Last Contacted None Displays the last time AMP was able to contact the WLSE server.
Polling Period 10 minutes Determines how frequently AMP polls WLSE to gather rogue scanning data.
Table 34 AMP Setup > WLSE Fields and Default Values (Continued)
Setting Default Description