Users Guide

64 | Configuring AMP Dell PowerConnect W-AirWave |Version 7.3
 The necessary files for either type of NMS interoperability are downloaded from the AMP Setup > NMS page
as follows. For additional information, contact support.
Perform these steps to configure NMS support in AMP:
1. Go to AMP Setup > NMS, illustrated in Figure 34.
Figure 34 AMP Setup > NMS Page Illustration
2. Select Add to integrate a new NMS server, or select the pencil icon to edit an existing server. Provide the
information described in Table 36:
3. The NMS Integration Add/Edit page includes the Netcool/OMNIbus Integration link to information and
instructions. The IBM Tivoli Netcool/OMNIbus operations management software enables automated event
correlation and additional features resulting in optimized network uptime.
4. The NMS Integration Add/Edit page includes the HP ProCurve Manager Integration link. Select this link
for additional information, zip file download, and brief instructions for installation with AMP. Select Add to
finish creating the NMS server, or Save to configure an existing NMS server.
What Next?
 Go to additional tabs in the AMP Setup section to continue additional setup configurations.
 Complete the required configurations in this chapter before proceeding.
Table 36 AMP Setup > NMS Integration Add/Edit Fields and Default Values
Setting Default Description
Hostname None Cites the DNS name or the IP address of the NMS.
Port 162 Sets the port AMP uses to communicate with the NMS.
NOTE: AMP generally communicates via SNMP traps on port 162.
Community String None Sets the community string used to communicate with the NMS.
SNMP Version v2C Sets the SNMP version of the traps sent to the Host.
Enabled Yes Enables or disables trap logging to the specified NMS.
Send Configuration Traps Yes Enables NMS servers to transmit SNMP configuration traps.