Users Guide

110 | Discovering, Adding, and Managing Devices Dell PowerConnect W AirWave 7.2 | User Guide
Running a Scan Set
Once a scan has been defined on the Device Setup > Discover page, AWMS can now scan for devices. Perform
these steps.
1. Browse to the Device Setup > Discover page and locate the list of all scan sets that have been defined so far.
Figure 67 illustrates this page.
Figure 67 Device Setup > Discover Executing a Scan Illustration
2. Check the box next to the scan(s) that you would like to execute.
3. Select Scan to execute the selected scans, and the scan immediately begins. The last column indicates the
scan is In Progress.
4. For future scans, select Show Scheduling Options and enter the desired date and time.
5. After several minutes have passed, refresh the browser page and view the results of the scan. When the Start
and Stop columns display date and time information, the scan is available to display the results.
6. Select the pencil icon for the scan to display the results. Table 71 describes the scan results and related
information.
7. Go to the APs/Devices > New page to see a full list of the newly discovered devices that the scan detected.
Figure 68 illustrates this page.
Table 71 Device Setup > Discover > Discovery Execution Fields
Column Description
Network Displays the network to be scanned.
Credentials Displays the credentials used in the scan.
Total Devices Found Displays the total number of APs detected during the scan that AWMS can configure and monitor. Total
includes both APs that are currently being managed by AWMS as well as newly discovered APs that
are not yet being managed.
New Devices Found Displays the number of discovered APs that are not yet managed, but are available.
Total Rogues Found Displays the total number of APs detected during the scan that AWMS could not configure or monitor.
Total includes both APs that have been discovered in earlier scans as well as newly discovered APs
from the most recent scan.
New Rogues Found Displays the number of rogue APs discovered on the most recent scan.
Start Displays the date and time the most recent scan was started.
Stop Displays the date and time the scan most recently completed.
Scheduled Displays the scheduled date and time for scans that are scheduled to be run.