Users Guide

200 | Performing Daily Administration in AWMS Dell PowerConnect W AirWave 7.2 | User Guide
Figure 142 Home > Overview Page Illustration
Table 117 Home > Overview Sections and Charts
Section Description
Users This chart is a graphical summary of the number of users on the network during a period of time. The time
can be adjusted. Select Show All to display a list of data series that this graph can display, such as the user
count by SSID.
Clear the Max Users or Avg Users checkbox to change the display of the graph. The graph displays the
maximum number of users by default. To view historical graphs in a new window, select the three-bar icon
on the upper right of the chart.
Bandwidth This adjustable chart displays bandwidth data over time. To remove bandwidth in or out from the graphical
display, clear the check box for Avg Bits Per Second In or Out.
To display details for specific devices, select Show All and select the devices to be included in the graphical
bandwidth summary chart. To view historical graphs in a new window, select the three-bar icon on the upper
right of the chart.
Monitoring
Status
This pie chart shows the percentage of all devices that are up and down on the network. To review devices
that are down, select Down in the legend or the chart, and the APs/Devices > Down page displays.
Configuration
Compliance
The pie chart displays all known device configuration status on the network. Devices are classified as Good,
Unknown, Mismatched, or Audit Disabled. Select the Mismatched link to see the APs/Devices > Mismatched
page.
Alert Summary This section displays all known and current alerts configured and enabled in the System > Alerts page. Alerts
can be sorted using the column headers (Type, Last 2 Hours, Last Day, Tota l, or Last Event). The Alert
Summary field displays four types of alerts, as follows:
 AMP Alerts
 IDS Events
 Incidents
 RADIUS Authentication Issues
Select any alert type for more information.
NOTE: The Incidents section only increments the counter for incidents that are open and associated to an
AP. This is also the case if you select Incidents and view incident details. To view all incidents including
those not associated to an AP, go to Helpdesk > Incidents.