Users Guide

258 | Third-Party Security Integration for AWMS Dell PowerConnect W AirWave 7.2 | User Guide
 AWMS version 1.5 or higher
 Completion of the AMP Setup > Radius Accounting page configurations, as described in “Integrating a
RADIUS Accounting Server” on page55.
ReefEdge Configuration
Perform these steps to configure a ReefEdge security scheme:
1. Log in into the ReefEdge ConnectServer via HTTP with the proper user credentials.
2. Navigate to the Connect System > Accounting page.
3. Select Enable RADIUS Accounting.
4. Enter the Primary Server IP Address or DNS entry for AWMS server.
5. Enter Primary Server Port Number 1813.
6. Enter the Shared Secret (matching the AWMS shared secret).
7. To verify and view the log files on the Connect Server proceed to Monitor > System Log.
8. To verify and view the log files on AWMS, proceed to System > Event Log.
HP ProCurve 700wl Series Secure Access Controllers Integration
A ProCurve security scheme for AWMS has the following prerequisites:
 HP 700 version 4.1.1.33 or higher
 AWMS version 3.0.4 or higher
 Completion of the AMP Setup > Radius Accounting page configurations, as described in “Integrating a
RADIUS Accounting Server” on page55.
Example Network Configuration
In this example, the APs are connected to the Access Controller. The Access Controller routes wireless user traffic
to the Employee Network, while bridging AP management traffic. Each AP is presumed to have a static IP
address.
Perform these steps for HP ProCurve 700wl Series Configuration, allowing AWMS to manage APs through
Control pages.
1. Log in to the Access Control Server via HTTP with proper credentials.
2. Navigate to Rights > Identity Profiles.
3. Select Network Equipment.
4. Enter the Name, LAN MAC and ensure the device is identified as an Access Points in the Identity Profile
section for all access points in the network.
The Access Points Identity Profile is the default profile for network equipment. Enabling this option instructs
the Access Controller to pass management traffic between the Access Points and the Customer's wired
network.
HP ProCurve 700wl Series Configuration
This procedure enables the sending of client authentication information to AWMS. Perform the following steps
to enable this configuration.
1. Log in to the Access Control Server via HTTP with proper credentials.
2. Navigate to the Rights > Authentication Policies configuration page.
3. Select Authentication Services.