Users Guide

Dell PowerConnect W AirWave 7.2 |User Guide Configuring AWMS | 61
2. After you have completed all fields, select Save. AWMS is now configured to gather rogue information from
WLSE rogue scans. As a result of this configuration, any rogues found by WLSE appear on the RAPIDS >
Rogue page.
What Next?
 Go to additional tabs in the AMP Setup section to continue additional setup configurations.
 Complete the required configurations in this chapter before proceeding. Dell support remains available to you for
any phase of AWMS installation.
Configuring ACS Servers
This is an optional configuration. The AMP Setup > ACS page allows AWMS to poll one or more Cisco ACS
servers for wireless username information. When you specify an ACS server, AWMS gathers information about
your wireless users. Refer to “Configuring TACACS+ and RADIUS Authentication” on page52 if you want to
use your ACS server to manage your AWMS users.
Perform these steps to configure ACS servers:
1. Go to the AMP Setup > ACS page. This page displays current ACS setup, as illustrated in Figure 29.
Figure 29 AMP Setup > ACS Page Illustration
2. Select Add to create a new ACS server, or select a pencil icon to edit an existing server. To delete an ACS
server, select that server and select Delete. When selecting Add or edit, the Details page appears, as
illustrated in Figure 30.
Poll for AP Discovery; Poll
for Rogue Discovery
Yes Sets the method by which AWMS uses WLSE to poll for discovery of new APs and/or
new rogue devices on the network.
Last Contacted None Displays the last time AWMS was able to contact the WLSE server.
Polling Period 10 minutes Determines how frequently AWMS polls WLSE to gather rogue scanning data.
Table 32 AMP Setup > WLSE Fields and Default Values (Continued)
Setting Default Description