Users Guide

88 | Configuring and Using Device Groups Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 55 illustrates these components and this navigation:
Figure 55: Groups > Cisco WLC Config > Security Navigation Illustration
Configuring Management Settings for Cisco WLC
AirWave allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. You can configure
up to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global Groups. To define
SNMP and server settings, go to the Groups > Cisco WLC Config > Management page, illustrated in Figure 56.
Figure 56: Groups > Cisco WLC Config > Management Navigation Illustration
Configuring Group PTMP Settings
The Groups > PTMP configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base
stations in the device group. Subscriber stations must be in the same group as all base stations with which they
might connect.
Perform the following steps to configure these functions.
1. Go to the Groups > List page and select the group for which to define PTMP settings by selecting the group
that supports Proxim MP.11. Alternatively, select Add from the Groups > List page to create a new group.
2. Select the Groups >PTMP tab. Figure 57 illustrates this page.