Users Guide

292 | Using VisualRF Dell PowerConnect W-AirWave 7.6 | User Guide
Viewing an AP’s Wireless RF Environment
To view an access point's RF environment from APs/Devices > Monitor page:
1. Select a device of interest from APs/Devices > List, or any other AirWave page that lists your APs. The
APs/Devices > Monitor page opens.
2. Click on the QuickView thumbnail showing the location of the AP, shown on the right side of Figure 226:
Figure 226: QuickView Thumbnail in APs/Devices > Monitor page for an AP
A fully interactive QuickView display opens below the thumbnail- on the same page (not in a new window), as
shown in Figure 227:
Figure 227: Full QuickView in APs/Devices > Monitor page for an AP (partial view)
This view is focused on enabling quick resolution of AP issues and therefore disables many RF objects by default
as follows:
n Clients - only clients associated with radios within access point of focus are displayed
n APs - only the access point in focus is displayed
n Radios - the heatmap represents all radios within the access point of focus
n Rogues - all rogues are off
n Client/Rogue Surveys - all surveys are off
n Walls - all walls on displayed
n Lines - client to AP of association are displayed
n Labels - all labels are disabled