Users Guide

20 | Configuring AirWave Dell PowerConnect W-AirWave 7.6 | User Guide
Setting Default Description
Guest User
Configuration
Disabled
Enables or prevents guest users to/from pushing configurations to devices.
Options are Disabled (default), Enabled for Devices in Manage (Read/Write),
Enabled for all Devices.
Allow WMS Offload
configuration in
monitor-only mode
No
When Yes is selected, you can enable the ArubaOS WMS offload feature on
the Groups > Basic page for WLAN switches in Monitor Only mode. Enabling
WMS offload does not cause a controller to reboot. This option is supported
only for Aruba and Dell PowerConnect W-Series devices.
Allow disconnecting
users while in
monitor-only mode
No
Sets whether you can deauthenticate a user for a device in monitor-only mode.
If set to No, the Deauthenticate Client button for in a Clients > Client Detail
page is enabled only for Managed devices.
Use Global Dell
PowerConnect W
Configuration
No
Enables Dell configuration profile settings to be globally configured and then
assigned to device groups. If disabled, settings can be defined entirely within
Groups > Dell PowerConnect W Config instead of globally.
NOTE: Changing this setting may require importing configuration on your
devices. When an existing Dell PowerConnect W-Series configuration setup is
to be converted from global to group, follow these steps:
1. Set all the devices to Monitor Only mode before setting the flag.
2. Each device Group will need to have an import performed from the Audit
page of a controller in the AMP group.
3. All of the thin APs need to have their settings imported after the device
group settings have finished importing.
4. If the devices were set to Monitor Only mode, set them back to Managed
mode.
Table 7: AMP Setup > General > Device Configuration Section Fields and Default Values
AMP Features
Locate the AMP Features section and adjust settings to enable or disable VisualRF and RAPIDS. Table 8 describes
these settings and default values.
Setting Default Description
Display VisualRF No Enable or disable the VisualRF navigation tab.
Display RAPIDS No Enable or disable the RAPIDS navigation tab.
Hide setup pages from
non-admin users
Yes
Restrict access to following pages to users with the AMP Administration role only:
l VisualRF > Setup
l AMP Setup > NMS
l RAPIDS > Score Override
l RAPIDS > Rules
l RAPIDS > Setup
l System > Triggers
Allow role based
report visibility
Yes
Enable or disable role-based reporting in AMP. When disabled, reports can only be
generated with by-subject visibility.
Table 8: AMP Setup > General > AMP Features Fields and Default Values
External Logging Settings
Locate the External Logging section and adjust settings to send audit and system events to an external syslog server.
Table 9 describes these settings and default values. You can also send a test message using the Send Test Message