Users Guide

42 | Configuring AirWave Dell PowerConnect W-AirWave 7.6 | User Guide
3. Locate the SNMPv3 Informs section. Select the Add button to reveal configuration options. AirWave users will
need to configure all v3 users that are configured on the controller. The SNMP Inform receiver in the AirWave
will be restarted when users are changed or added to the controller.
l Username - Username of the SNMP v3 user as configured on the controller.
l Auth Protocol - Can be MD5 or SHA. The default setting is SHA.
l Auth and Priv Protocol Passphrases - Enter the authentication and privilege protocol passphrases for the user
as configured on the controller.
l Priv Protocol - Can be DES or AES. The default setting is DES..
NOTE: This form allows you to edit existing SNMPv3 users by selecting the pencil icon next to the desired user. It also allows you to
remove existing users by selecting the user’s checkbox and then clicking Delete.
4. Locate the Telnet/SSH Settings section, and complete or adjust the default value for the field. Table 27 shows
the setting and default value.
Setting Default Description
Telnet/SSH Timeout
(3-120 sec)
10 Sets the timeout period in seconds used when performing Telnet and SSH commands.
Table 27: Device Setup > Communication > Telnet/SSH Settings Fields and Default Values
5. Locate the HTTP Discovery Settings section and adjust the default value. Table 28 shows the setting and
default value.
Setting Default Description
HTTP Timeout
(3-120 sec)
5 Sets the timeout period in seconds used when running an HTTP discovery scan.
Table 28: Device Setup > Communication > HTTP Discovery Settings Fields and Default Values
6. Locate the ICMP Settings section and adjust the default value as required. Table 29 shows the setting and
default value.
Setting Default Description
Attempt to
ping devices
that were
unreachable
via SNMP
Yes
l When Yes is selected, AirWave attempts to ping the AP device.
l Select No if performance is affected in negative fashion by this function. If a large
number of APs are unreachable by ICMP, likely to occur where there is in excess of 100
APs, the timeouts start to impede network performance.
NOTE: If ICMP is disabled on the network, select No to avoid the performance penalty
caused by numerous ping requests.
Table 29: Device Setup > Communication > ICMP Settings Fields and Default Values
7. Locate the Symbol 4131 and Cisco Aironet IOS SNMP Initialization area. Select one of the options listed.
Table 30 describes the settings and default values