Users Guide

Setting Default Description
4.9GHz Public Safety
Channel Bandwidth
20
This setting specifies the channel bandwidth for the 4.9 GHz radio. It is only
applicable if you are running the 802.11a/4.9GHz radio in 4.9GHz mode.
802.11a/4.9GHz Public
Safety Operational
Mode
802.11a
This setting specifies if the AP will run the 802.11a/4.9GHz radio in 802.11a mode or
in 4.9 GHz mode. Please note that 4.9 GHz is a licensed frequency used for public
safety.
Table 62: Groups > Radio > Proxim 4900M Fields and Default Values
7. To configure Symbol-only settings, locate the Symbol section and define the required fields. Table 63 describes
the settings and default values.
Setting Default Description
Rogue Scanning Yes
If enabled, Symbol access points with 3.9.2 or later firmware in the group will passively
scan for rogue access points at the specified interval. This rogue scan will not break a
user’s association to the network.
Rogue Scanning
Interval (5-480 min)
240
If Rogue Scanning is enabled, this setting controls the frequency with which scans are
conducted (in minutes). Frequent scans provide the greatest security, but AP performance
and throughput available to user devices may be impacted modestly during a rogue scan.
Table 63: Groups > Radio > Symbol Fields and Default Values
8. Select Save when radio configurations as described above are complete, select Save and Apply to make the
changes permanent, or select Revert to discard all unapplied changes.
Cisco WLC Group Configuration
The Groups > Cisco WLC Config page consolidates the settings for Cisco WLC devices from all group pages. The
Groups > SSIDs subtab applies to all device types except for Cisco WLC, which have WLANs configured on the
Cisco WLC Config page. It is not recommended to have Symbol 4131 and Proxim APs in the same group as Cisco
devices. Also, it is recommended that users set device preferences to Only devices in this group. This topic
describes how to access and navigate the Groups > Cisco WLC Config page.
Accessing Cisco WLC Configuration
Go to the Cisco WLC Config page in one of these two ways:
1. In Groups > List, select a group that has been defined to support Cisco devices. The Cisco WLC Config option
appears in the subtabs.
2. In Groups > List, create a new group to support Cisco devices with these steps:
n Select Add from the Groups > List page to create a new group, enter a group name, and select Add.
n Once AirWave prompts you with the Groups > Basic page, ensure that you enable device-specific settings for
Cisco WLC.
n After you select Save or Save and Apply, the Groups > Cisco WLC Config subtab appears in the navigation
pane at the top in association with that group.
Dell PowerConnect W-AirWave 7.6 | User Guide Configuring and Using Device Groups | 81