Users Guide

Figure 32:Cisco WLC Submenu in the Navigation Bar
Navigating Cisco WLC Configuration
The navigation pane on the left side of the Groups > Cisco WLC Config page is expandable, and displays the
Cisco configurations supported and deployed. Figure 33 and illustrate this navigation pane.
You can pre-populate the group WLC settings from a controller in the same group by performing an import on
the controller’s Audit page.
Figure 33:Groups > Cisco WLC Config Page Illustration, collapsed view
Configuring WLANs for Cisco WLC Devices
In Cisco WLC Config, WLANs are based on SSIDs or VLANs that are dedicated to Cisco WLC controllers. Perform
the following steps to define and configure WLANs for Cisco WLC controllers.
1. Go to the Groups > Cisco WLC Config page, and select WLANs in the left navigation pane. This page
displays the SSIDs or VLANs that are available for use with Cisco WLC devices and enables you to define new
SSIDs or VLANs. illustrates this page.
2. To change the ID/position of a WLAN on the controller by dragging and dropping, set the toggle to Yes. Note
that the by setting this flag to Yes, W-AirWave will display a mismatch if the WLANs in the desired config and
device config differ only on the order.
3. To add or edit SSIDs or VLANs that are dedicated to Cisco WLC devices, either select the Add button, or select
the pencil icon for an existing SSID/VLAN. A new page appears comprised of four tabs, as follows:
Dell Networking W-AirWave 8.2.4 | User Guide Configuring and Using Device Groups | 100