Users Guide

111 | Configuring and Using Device Groups Dell Networking W-AirWave 8.2.4 | User Guide
7. Browse to the AMP Setup >General page.
8. In the General section, select the desired group from the Default Group drop down menu to make it the
default.
For more information about loading firmware on to an W-AirWave server, see "Loading Device Firmware Onto the W-
AirWave Server (optional)" on page 55.
Comparing Device Groups
You can compare two existing device groups with a detailed line-item comparison. Group comparison allows
several levels of analysis including the following:
l Compare performance, bandwidth consumption, or troubleshooting metrics between two groups.
l Debug one device group against the settings of a similar and better performing device group.
l Use one group as a model by which to fine-tune configurations for additional device groups.
This topic presumes that at least two device groups are at least partly configured in W-AirWave, each with saved
configurations. Perform the following steps to compare two existing device groups:
1. From the Groups > List page, select the Compare two groups link. Two drop-down menus appear.
2. Select the two groups to compare in the drop-down menus, and select Compare. The Compare page
appears, displaying some or many configuration categories. Figure 47 illustrates this page.