Users Guide

Setting Default Device
Type
Description
WDS Role Client Cisco IOS
Wireless
LAN
Controllers
only
Set the WDS role for this AP. Select Master for the WDS
master APs and Client for the WDS Client. Once this is done
you can use the %if wds_role= % to push the client, master, or
backup lines to appropriate WDS APs.
SSL Certificate None Cisco IOS W-AirWave will read the SSL Certificate off of the AP when it
comes UP in W-AirWave. The information in this field will
defines what will be used in place of %certificate%.
Extra Device
Commands
None Cisco IOS Defines the lines that will replace the %ap_include_1%
variable in the IOS template. This field allows for unique
commands to be run on individual APs. If you have any
settings that are unique per AP like a MOTD you can set them
here.
switch_command None Cisco
Catalyst
switches
Defines lines included for each of the members in the stack.
This field appears only on the master's Manage page. The
information in this field will determine what is used in place of
the %switch_command% variable.
Table 89: APs/Devices > Manage > Template Options Fields and Default Values
6. For Cisco WLC devices, go to the interfaces section of the APs/Devices > Manage page. Select Add new
Interface to add another controller interface, or select the pencil icon to edit an existing controller interface.
Table 90 describes the settings and default values. For detailed descriptions of Cisco WLC devices supported
by W-AirWave, refer to the Cisco WLC product documentation.
Field Default Description
Name None The name of the interface on the controller.
VLAN ID None The VLAN ID for the interface on the controller.
Port None The port on the controller to access the interface.
IP Address None The IP address of the controller.
Subnet Mask None The subnet mask for the controller.
Gateway None The controller's gateway.
Primary and
Secondary DHCP
Servers
None The DHCP servers for the controller.
Guest LAN Disabled Indicates a guest LAN.
Quarantine VLAN ID Disabled Enabled indicates it is a quarantine VLAN; used only for H-REAP-
associated clients.
Dynamic Device
Management
Enabled When enabled, makes the interface an AP-manager interface. Cisco calls
this feature Dynamic AP Management.
Table 90: APs/Devices > Manage > Interface Fields and Descriptions for Cisco WLC Devices
Dell Networking W-AirWave 8.2.4 | User Guide Configuring and Managing Devices | 172