Users Guide

The following example sets an AP as a WDS Master with the following lines:
%if wds_role=master%
aaa authentication login method_wds group wds
aaa group server radius wds server
10.2.25.162 auth-port 1645 acct-port 1646
wlccp authentication-server infrastructure method_wds
wlccp wds priority 200 interface BVI1
wlccp ap user name wlse password 7 095B421A1C
%endif%
The following example sets an AP as a WDS Master Backup with the following lines:
%if wds_role=backup%
aaa authentication login method_wds group wds
aaa group server radius wds server
10.2.25.162 auth-port 1645 acct-port 1646
wlccp authentication-server infrastructure method_wds
wlccp wds priority 250 interface BVI1
wlccp ap user name wlse password 7 095B421A1C
%endif%
SCP Required Settings in Templates
A few things must be set up before enabling SCP on the Groups > Basic configuration page. The credentials
used by W-AirWave to login to the AP must have level 15 privileges. Without them, W-AirWave is not able to
communicate with the AP via SCP. The line "aaa authorization exec default local" must be in the APs
configuration file and the AP must have the SCP server enabled. These three settings correspond to the following
lines in the AP’s configuration file:
user name Cisco privilege 15 password 7 0802455D0A16
aaa authorization exec default local
ip scp server enable
The user name line is a guideline and will vary based on the user name being set, in this case Cisco, and the
password and encoding type, in this case 0802455D0A16 and 7 respectively.
These values can be set on a group wide level using Templates and TFTP. Once these lines are set, SCP can be
enabled on the Groups > Basic configuration page without problems.
Supporting Multiple Radio Types via a Single IOS Template
Some lines in an IOS configuration file should only apply to 802.11g vs. 802.11b. For instance, lines related to
speed rates that mention rates above 11.0Mb/s do not work for 802.11b radios that cannot support these
speeds. Use the "%IF variable=value% … %ENDIF%" construct to allow a single IOS configuration template to
configure APs with different radio types within the same Group as illustrated below:
interface Dot11Radio0
…
%IF radio_type=g%
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
%ENDIF%
%IF radio_type=b%
speed basic-1.0 2.0 5.5 11.0
%ENDIF%
%IF radio_type=g%
power local cck %CCK_POWER%
power local ofdm %OFDM_POWER%
%ENDIF%
…
Dell Networking W-AirWave 8.2.4 | User Guide Creating and Using Templates | 192