Users Guide

l Clients > Connected or Client Detail
l System > Alerts
Clicking any of the hyperlinks in the Type column opens a detailed view for the selected alert.
Figure 124:Alert Summary on the APs/Devices > Monitor page
For information about setting the severe alert threshold, see "Setting Severe Alert Warning Behavior" on page 27.
Types of Alerts
AMP Alerts
Click the AMP Alerts link shown in Figure 124to open the AMP Alerts page. This page includes a Summary table
that describes the AirWave (AMP) Alert type, and the number of times that event occurred over the past 2 hours
and the last 24 hours. The Alerts table appears below the Summary table, and includes the following
information for each AMP Alert:
l Trigger Type: Name of the AMP Alert trigger
l Trigger Summary: Description of the AMP Alert trigger
l Triggering Agent: MAC address of the device that triggered the alert
l Severity: Alert severity level
l Time: Timestamp for the alert
IDSEvents
Click the IDSEvents link shown in Figure 124 to open the IDSEvents page. This page includes a Summary table
that describes the Intrusion Detection System (IDS) event type, and the number of times that event occurred
over the past 2 hours and the last 24 hours. The IDSEvents table appears below the Summary table, and
includes the following information for each IDS eventt:
l Severity: Event severity level
l Category: IDS category for the event
l Scope: Indicates of the scope of the IDS event impacts an AP, Client or AP, Client or Probe.
l Attack: Name of the IDS Event
l Detail: Details about the IDS Event type, if available
l Attacker: MAC address of the device that triggered the IDS event
l Target: MAC address of the device that was the target of the IDS attack
l Time: Timestamp for the event
Dell Networking W-AirWave 8.2.4 | User Guide Performing Daily Administration in W-AirWave | 230