Users Guide

about bandwidth information, see "Using the Network Usage Report" on page 269.
Example Custom Report
The following example creates a report looks for devices that are under-utilized. This report will search for
devices over a 2-hour period that were at 1% of capacity for 5-100% of the time. Any setting omitted from this
example remains the default value.
1. Navigate to Reports > Definitions, then click Add New Report Definition.
2. Enter the title, "Capacity Planning Report 1% for Group HQ".
3. Select Capacity Planning from the Type drop-down menu.
4. Select "HQ" from the Groups drop down menu.
5. Set the capacity threshold to 1.
6. Set the minimum time above the threshold to 5.
7. Set the maximum time above the threshold to 100.
8. Enter a 2-hour time interval for the report to run.
9. Click Save and Run. The report displays on the Generated Reports page when it is available, as shown in
Figure 152.
Figure 152:Capacity Planning Report
Table 131describes the fields in the Capacity Planning Report.
Field Description
Device Displays the device type or name.
Interface Displays the type of 802.11 wireless service supported by the device.
Group Displays the device group with which the device is associated.
Table 131: Capacity Planning Report Fields and Descriptions
Dell Networking W-AirWave 8.2.4 | User Guide Creating, Running, and Sending Reports | 274