Users Guide

283 | Creating, Running, and Sending Reports Dell Networking W-AirWave 8.2.4 | User Guide
Figure 157:Device Uptime Report Illustration
Field Description
SNMP Uptime Displays the percentage of time the device was reachable via ICMP. W-AirWave polls the
device via SNMP at the rate specified on the Groups > Basic page.
ICMP Uptime Displays the percentage of time the device was reachable via ICMP. If the device is
reachable via SNMP it is assumed to be reachable via ICMP. W-AirWave only pings the
device if SNMP fails and then it pings at the SNMP polling interval rate.
Time Since Last
Boot
The uptime as reported by the device at the end of the time period covered by the
report.
Table 136: Device Uptime Report Unique Fields and Descriptions
Using the Inventory Report
The Inventory Report itemizes all devices on the network. The output breaks down this information by vendor,
model (including firmware and bootloader), and device type.
Example Custom Report
The following example creates a report of all Cisco devices on your network. Any field omitted from this example
remains the default value.
1. Navigate to Reports > Definitions, then click Add New Report Definition.
2. Enter the title "Cisco Devices Inventory."