Users Guide

29 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
Nightly
Maintenance
Time (00:00 -
23:59)
04:15 Specifies the local time of day W-AirWave should perform daily
maintenance. During maintenance, W-AirWave cleans the database,
performs backups, and completes a few other housekeeping tasks.
Such processes should not be performed during peak hours of
demand.
License APs
Usage Threshold
90
Sets a threshold to display an alert on the controller monitor page
when the license usage has reached this number.
Table 3: AMP Setup >General > General Section Fields and Default Values (Continued)
Automatic Authorization Settings
On the AMP Setup > General page, locate the Automatic Authorization section. These settings allow you to
control the conditions by which devices are automatically authorized into AP groups and folders. W-AirWave
validates the Folder and Group to ensure that both settings have been set to valid drop down options. Table 4
describes the settings and default values in this section.
Setting Default Description
Add New
Controllers and
Autonomous
Devices Location
New Device List Globally add new controllers and autonomous devices to:
l The New Device List (located in APs/Devices > New).
l The same folder and group as the discovering device.
l The same group and folder of their closest IP neighbor on the
same subnet.
l Choose a group and folder. If you select this option, enter the
folder/group in the Auto Authorization Group and Auto
Authorization Folder fields that display.
NOTE: This setting can be overridden in Groups > Basic.
Add New Thin APs
Location
New Device List Globally add new thin APs to:
l The New Devices list.
l The same folder and group as the discovering device.
l The same group and folder of their closest IP neighbor on the
same subnet.
l Choose a group and folder. If you select this option, enter the
folder/group in the Auto Authorization Group and Auto
Authorization Folder fields that display.
NOTE: This setting can be overridden in Groups > Basic.
Automatically
Authorized Virtual
Controller Mode
Manage
Read/Write
Specify whether Virtual Controller mode for Instant APs will be in
Manage Read/Write mode or Monitor Only mode.
Table 4: AMP Setup > General > Automatic Authorization Fields and Default Values
Dell Instant Settings
A Virtual Controller can communicate with the W-AirWave server over a configurable communication port, and
authenticate to the server using a pre-shared key, and/or two-way certificate-based authentication using an SSL
certificate sent from W-AirWave to the Instant device.
The AMP Setup > General > Dell Instant Options page includes the following Configuration settings: