Users Guide
Setting Default Description
Communication
port (443,1000-
65534):
443 By default, an Instant Virtual Controller communicates with AirWave over
port 443. If your enterprise has a security policy that restricts the use of
port 443 for inbound communication, use this field to change the port the
Virtual Controller uses to communicate with W-AirWave.
Security method
for adding new
Virtual Controllers:
PSK Only
W-AirWave can use any of the following security methods to authenticate
a Virtual Controller to the W-AirWave server.
l PSK Only
l PSK and Certificate
l Certificate Only
If you enable certificate authentication, you are directed to the AMP
Setup > General > Upload SSLCertificate page, where you are
prompted to upload an certificate file in PEM format that contains
containing both a private key and certificate.
Configuration Only No By default, W-AirWave will push Instant configuration settings as well as
W-AirWave settings such as RAPIDS settings and traps from an W-
AirWave group to a Virtual Controller assigned to that group. Select the
Yes option to push Instant configuration settings only.
Table 5: AMP Setup > General > DellInstantOptions Fields and Default Values
If you select a security method that includes Certificate-based authentication, you must upload the a certificate
from a supported certificate authority to the W-AirWave server, as the default W-AirWave certificate will not be
recognized by the Instant AP, and will cause the SSL handshake to fail. Certificate authentication also requires
that the AirWave IPaddress information configured on the Instant AP is a domain name, and not an IP
address.
W-AirWave supports the following trusted certificate authorities:
l Chain 1: Trusted Root CA: C=SE, O=AddTrust AB, OU=AddTrust External TTP Network, CN=AddTrust External
CA Root Intermediate CA: C=GB, ST=Greater Manchester, L=Salford, O=COMODO CA Limited, CN=COMODO
High-Assurance Secure Server CA
l Chain 2: Trusted Root CA: C=US, O=GeoTrust Inc., CN=GeoTrust Global CA Intermediate CA: Subject: C=US,
O=Google Inc, CN=Google Internet Authority G2
l Chain 3: Trusted Root CA: C=US, O=VeriSign, Inc., OU=VeriSign Trust Network, OU=(c) 2006 VeriSign, Inc. -
For authorized use only, CN=VeriSign Class 3 Public Primary Certification Authority - G5 Intermediate CA:
C=US, O=VeriSign, Inc., OU=VeriSign Trust Network, OU=Terms of use at https://www.verisign.com/rpa (c)10,
CN=VeriSign Class 3 Secure Server CA - G3
l Root CA: Trusted Root CA: C=US, O=Equifax, OU=Equifax Secure Certificate Authority
If you enable certificate authentication, you are prompted to upload an SSLcertificate. you can view the current
W-AirWave certificate using the View Certificate link on that page, or click Change to upload a new certificate
file to the W-AirWave server.
Top Header Settings
On the AMP Setup > General page, locate the Top Header section to select the Top Header Stats to be
displayed at the top of the interface.
Search Method
On the AMP Setup > General page, locate the Search Method section. Select one of the following drop down
options as the system-wide default search method. This default search type will be used when a user types an
entry in the Search field and then clicks Enter without selecting a specific search type.
Dell Networking W-AirWave 8.2.4 | User Guide Configuring W-AirWave | 30